Vans Aircraft Swedish Forum
Vill du reagera på det här meddelandet? Registrera dig för forumet med några klick eller logga in för att fortsätta.
Vans Aircraft Swedish Forum

Forum på svenska för alla typer av Vans aircraft.
 
HemHem  Latest imagesLatest images  SökSök  Bli medlemBli medlem  Logga in  

 

 Luftfilterboxen

Gå ner 
FörfattareMeddelande
Tboyner




Antal inlägg : 5
Registreringsdatum : 12-03-28
Ålder : 66
Ort : Täby

Luftfilterboxen Empty
InläggRubrik: Luftfilterboxen   Luftfilterboxen Emptytis okt 16, 2012 11:59 pm

En otrevlig upptäckt vid 100 timmars tillsynen...
Bifogar mejlväxling med Vans:

I'm afraid we have no idea where the missing bits may have gone.  These are inside the ring
of the air filter, so they may have been sucked into the carburetor -- although they would
probably cause enough damage that you'd know about it.



Forwarded by:    "Support"
Forwarded to:    kenS
Date forwarded:    Mon, 15 Oct 2012 06:21:23 -0700
Date sent:    Sun, 14 Oct 2012 21:32:25 +0200
From:    "t.boyner@bredband.net"
To:    
Subject:    Door to filtered airbox



Hi,
Having flown my RV-9A more than 170 hours now I must say it´s a
wonderful airplane.
Today however when doing my annual inspection I
found something strange. When lowering the lower cowling and
inspecting the air filter box (FAB 360/540) I found the bypass
door,(VA-192B), with its air inlet,(VA-192A) loose, only attatched to
the fiberglass housing with the screw holding the control cable.
A small piece of the filter
housing where the platenut K1000-08 was riveted was missing and so
were the 5 poprivets AK42-H that used to attatch the air inlet to the
filter housing.
Should I be nervous about this?- I mean could they have been
sucked into the engine or did they most likely fall out of the air
filter housing, onto the lower cowling and out in the airstream?
I
have now reinforced the fiberglass housing and added a bracket on the
inside so that the VA-192A has something more solid to be riveted to.

Best regards
Thomas Boyner
Kit 91648  

Detta gäller de som har "filtered air box" med en lucka i botten som kan öppnas med en wire från instrumentbrädan.
Jag har ingen förgasare utan direktinsprutning men lösa delar kan nog lika gärna sugas in i injektorhuset som in i en förgasare. Luftboxen är byggd enligt ritning men plasten är ganska tunn i originalutförandet så man kan tänka att vibrationer gör att popnitarna som håller infästningen till alternativa luftintaget gnager hål på plasten som i mitt fall.
Det märkliga är att popnitarna borde ha suttit fast i metallbrickan även om de lossnat från plasten men de är som sagt borta.
Jag har inte märkt något speciellt under flygning, så jag hoppas att popnitarna försvann " nedåt".
Thomas Boyner -XTB
Till överst på sidan Gå ner
 
Luftfilterboxen
Till överst på sidan 
Sida 1 av 1

Behörigheter i detta forum:Du kan inte svara på inlägg i det här forumet
Vans Aircraft Swedish Forum :: Your first category :: Alla inlägg-
Hoppa till: